Roland S-1608 Manual Do Utilizador
32
S-1608/S-0816 Digital Snake Owner’s Manual
6
Using the S-1608/S-0816 System
Installing the Rack-mount kit
S-1608 and S-0816
The S-1608 and S-0816 can be used in a free standing configuration, or rack-mounted using the
installed rack-mount kit.
installed rack-mount kit.
1.
Turn off the power on all equipment and disconnect all cables from the S-1608 or S-0816 unit.
2.
Remove only the screws shown in the following diagram (4 screws total).
fig.6-02.eps
Installation
Precautions for Rack Mounting
•
When mounting the S-1608 or S-0816 in a rack, observe the following precautions to ensure
efficient and effective cooling.
efficient and effective cooling.
-
Ensure that the location provides good air flow and ventilation.
-
Do not allow the vents to become obstructed.
-
Avoid using the S-1608 or S-0816 in sealed-type rack mounts. As this type of rack does not
permit heated air within the rack to be expelled, the heated air is drawn into the S-1608 or
S-0816 as a result, thus preventing adequately efficient cooling.
permit heated air within the rack to be expelled, the heated air is drawn into the S-1608 or
S-0816 as a result, thus preventing adequately efficient cooling.
-
If the rack’s rear panel is not removable, ensure that a ventilation port or exhaust fan is
provided at the top of the rack’s rear panel to expel any accumulated heat.
provided at the top of the rack’s rear panel to expel any accumulated heat.
-
If the S-1608 or S-0816 is mounted in a portable rack, remove both the front and rear rack
covers before use to ensure that the S-1608’s or S-0816’s front and rear panels remain
unobstructed.
covers before use to ensure that the S-1608’s or S-0816’s front and rear panels remain
unobstructed.
•
Use due caution when mounting the S-1608 or S-0816 in a rack or other enclosure so you don’t
get your fingers wedged or pinched.
get your fingers wedged or pinched.
S-1608_e.book 32 ページ 2007年4月23日 月曜日 午後12時57分