Korg SP-500 Manual Do Utilizador

Página de 87
30
To cancel Reverb
Press the [REVERB] switch to make the [REVERB] indicator lamp turn off.
You can apply modulation to the selected sound to create a sensation of rich spaciousness, or 
apply distortion to give the sound an Rock’n Roll character. These are called Effects.
1
Press the [CHORUS etc.] switch
The [CHORUS etc.] switch indicator will light, and an effect such as chorus will be 
applied to the sound.
2
Select the type of effect
Press the “Type” cell, and use the dial or the [VALUE] switches to change the selection.
List of effect types
1
Stereo Delay
Stereo delay
2
Cross Delay
Delay that alternates between left and right channels
3
Dual Delay
Independent mono delays for left and right channels
4
Multitap Dly1
A single sound will be repeated twice
5
Multitap Dly2
Same as above, but with different spacing of the two sounds
6
Multitap Dly3
Same as above
7
Chorus 1
Stereo chorus with left and right channels in opposite phase
8
Chorus 2
Stereo chorus with left and right channels in the same phase
9
Quad Chorus
Chorus where the left and right channels are 90 degrees out of phase
10
XOver Chorus
Crossover effect
11
Harmonic Cho. 
A chorus that is effective on low instruments such as bass
12
Symphonic Ens 
A chorus that is effective on strings
13
Flanger 1
Modulation with left and right channels in the same phase
14
Flanger 2
Modulation with left and right channels in opposite phase
15
XOver Flanger
Modulation in opposite phase, but with channels applying feedback to each other
16
Exciter
Adds sparkle to the sound to give it better definition
17
Enhancer
Gives the sound a sense of spaciousness
18
Distortion
Hard, solid-state distortion
19
Overdrive
Warm tube amp distortion
20
Phaser 1
Left and right channels modulated in opposite phase
21
Phaser 2
Left and right channels modulated in the same phase
22
Rotary Speakr
Simulation of a rotary speaker
23
Auto Pan
An effect that automatically pans the sound in stereo
24
Tremolo
Tremolo effect