Korg SP-200 Manual Do Utilizador

Hold down the TRANSPOSE/FUNCTION button, and press the PIANO 1 sound
selection button. The Local setting will alternate to On/Off each time you press this
button.

Note: When the power is turned on, the Local will be automatically set to On.

The sound of the SP-200 can be selected via MIDI, by sending a Program Change
message on the channel where you wish to assign the sound. The table enlists the
Program Change numbers (numbering from 0-29; if the transmitting device uses
numbers from 1-30, you will need to increment the number by one).

You can send a MIDI Program

Change message to a MIDI device connected to the SP-200 MIDI OUT, to change
its sound. When selecting one of the internal sounds of the SP-200 by using the
sound selection buttons, a MIDI Program Change number will be transmitted, as
shown in the table below.

When a Program Change message is

received from an external device, the corresponding internal sound will be selected
on the SP-200, as shown in the following table. Only Program Change (PC) num-
bers in the range 0–29 have effect on the SP-200, while other numbers (30-127) are
ignored.

Local On

Lit

Local Off

Dark

0

PIANO 1

1

Grand Piano 1

1

2

Bright Piano

2

3

Grand Piano 2

3

PIANO 2 

1

Classic Grand Piano

4

2

Honky-Tonky

5 3

E.Grand 

Piano

6

E.PIANO 1

1

Stage E.Piano

7

2

Club E.Piano

8

3

Thin E.Piano