Behringer 1202FX/1002FX Manual Do Utilizador

XENYX 1202FX/1002FX User Manual

4. Installation

4.1 Mains connection

AC POWER IN
Connect the power supply to the 3-pin mains connector on the rear of the

console. Use the AC adapter supplied to connect the console to the mains.

The adapter complies with all applicable safety standards.

◊

Please use only the power supply unit provided with the console.

◊

Never connect the XENYX to the power supply unit while the latter is
connected to the mains! First connect the console to the power supply
unit, then connect the power supply unit to the mains.

◊

Please note that both the power supply unit and the mixing console
heat up considerably during operation. This is completely normal.

4.2 Audio connections

You will need a large number of cables for different applications. The illustrations

below show how the connectors should be wired. Be sure to use only

high-grade cables.
Please use commercial RCA cables to connect the CD/tape inputs and outputs.
You can, of course, also connect unbalanced equipment to the balanced

inputs/outputs. To do this, use either mono plugs or stereo plugs with the ring

and sleeve bridged (pins 1 and 3 in the case of XLR connectors).

◊

Caution! Never use unbalanced XLR connectors (PIN 1 and 3 connected)
on the MIC input connectors when using the phantom power supply.

output

For unbalanced use, pin 1 and pin 3

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

input

Balanced use with XLR connectors

Fig. 4.1: XLR connections

Fig. 4.2: ¼" mono plug

strain relief clamp

sleeve

tip

sleeve

(ground/shield)

Unbalanced ¼" TS connector

tip

(signal)

strain relief clamp
sleeve
ring
tip

sleeve

ground/shield

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Balanced ¼" TRS connector

ring

cold (-ve)
tip

hot (+ve)

Fig. 4.3: ¼" stereo plug

strain relief clamp

sleeve
ring
tip

sleeve

ground/shield

¼" TRS headphones connector

ring

right signal
tip

left signal

Fig. 4.4: Stereo plug for headphones connection