American Dj Flash Tube Buffer Folheto

American DJ

User Instructions

Introduction:

Thank You and congratulations on your purchase

of the American DJ

Flash Tube Buffer

™

. This

buffer is a simple and easy way to extend the

range of your American DJ

Flash Matrix Hub

™

Flash-1C

™

, or Flash-2C

™

Flash Tube

™

controllers.

In some large venues it is sometimes necessary

to have extended cables run, due to the fact that

control booths are often located clear across the

room from any fixtures. This buffer will prevent

any signal degradation that may occur after exces-

sively long cable runs.

Function:

Your different Flash Tube

™

controllers (Flash

Matrix Hub

™

, Flash-1C

™

, or Flash-2C

™

) are

designed to handle total cable runs of 100ft. or

less. This total includes your Flash Tubes

™

and/or

any extension cables. This buffer is designed to

boost the output signal of your controller. The

buffer is designed to be placed at the end of your

first 100ft. run, not at the beginning. For Exam-

ple: If you have a fifty foot extension cable run-

ning from your controller to 20 Flash Tubes

™

(

Total

cable run of 150ft.

) the buffer must be placed after

the tenth Flash Tube

™

which is about 100ft. 100ft.

is an approximate measurement, you may need

to place your buffer sooner in the line if are getting

erratic behavior.

Set-Up & Operation:

1. Your Flash Tube Buffer™ must be plugged

into a standard 120v Edison wall outlet. Please

install a standard 3 (three) prong electrical recep-

tacle to the exposed electrical wires (See Figure

1). Be sure to follow the manufactures guidelines

for proper installation of the electrical receptacle.

2. Connect the buffer in line with your system.

This will either be between two (2) Flash Tubes

™

or between a Flash Tube

™

and an extension

cable. Please note, there is two different types of

ends on the buffer an in and an out.

3. Plug your buffer into a 120v electrical outlet.

Operate your Flash Tube

™

controller as

directed.

Figure 1

Electrical Connection

American DJ

Los Angeles Ca. 90058 - www.americandj.com - Flash Tube Buffer™

Flash Tube Buffer

™