Yamaha RS500 Manual Do Utilizador
2
RS500/RS700 Owner’s Manual
1.
Remove the rack from its box and stand it up with the drum trigger module clamp and the left leg positioned on the right
as shown in Figure 1.
as shown in Figure 1.
2.
With the rack standing up, loosen the bolts q located on the left and rotate the left leg towards you until it is positioned
as shown in Figure 1 Top view.
as shown in Figure 1 Top view.
• The bolts q can be found on the rear of the clamp on the left pillar.
3.
Loosen the bolts w located on the right in Figure 2 and rotate the right leg clockwise from the left until it comes fully
around as shown in Figure 2 Top view.
around as shown in Figure 2 Top view.
• The bolts w can be found on the rear of the clamp on the right pillar.
4.
Tighten the bolts loosened in Steps 2 and 3 above.
Setting up RS500
Bolts q
[Figure 1]
Right leg
Left leg
Left pillar
Drum trigger
module clamp
module clamp
2
2
[Figure 1 Top view]
Left leg
Right leg
Left pillar
Right pillar
2
Right pillar
[Figure 2]
Bolts
w
Left leg
Right leg
Right pillar
Left pillar
3
Drum trigger
module clamp
module clamp
[Figure 2 Top view]
Left leg
Right leg
Left pillar
Right pillar
3
CAUTION
• The rack may topple over and cause
injury if the left and right legs are
opened any wider than shown in the
figure below. You should not, there-
fore, exceed the dimensions indicated.
opened any wider than shown in the
figure below. You should not, there-
fore, exceed the dimensions indicated.
rs500_700_en_1224.fm Page 2 Friday, December 24, 2010 9:15 AM