John Deere RT 1165 Manual Do Utilizador
4. Install PTO shaft to tractor.
IMPORTANT: Tiller MUST BE level front to rear.
• Engage the cardan shaft and check that it is perfectly
locked on the tractor PTO (G). Check that the guard
(H) is free to turn and fi x it with the relative latch.
(H) is free to turn and fi x it with the relative latch.
5. Raise tiller.
6. Remove spring locking pin (K) from parking stand.
7. Slide parking stand (I) all the way up on tiller bracket
(J).
8. Fasten with spring locking pin (K).
9. Level tiller (See Leveling Tiller in the Operating Tiller
section).
10. Adjust sway chains on tractor lower draft arms to
minimize side way.
PTO shaft
The PTO shaft, supplied with the machine, is of standard
length.
Therefore it might be necessary to adapt the PTO shaft.
In that case, before doing anything, consult the Manufac-
turer for the eventual adaptation.
length.
Therefore it might be necessary to adapt the PTO shaft.
In that case, before doing anything, consult the Manufac-
turer for the eventual adaptation.
When the PTO shaft is fully extended, the two tubes must
overlap by at least 15 cm (A). When fully inserted, the
minimum play must be 4 cm (B).
overlap by at least 15 cm (A). When fully inserted, the
minimum play must be 4 cm (B).
CAUTION: If the implement is used on
another tractor, always check the that the
guards completely cover the rotating parts
of the PTO shaft.
another tractor, always check the that the
guards completely cover the rotating parts
of the PTO shaft.
A
B
INSTALLING
Installing - Page 12
H
K
J
I
G