Ridgid R5010 Manual Do Utilizador

9

Always wear safety goggles or safety glasses with
side shields when operating this tool. Failure to do
so could result in dust, shavings, or loose par-
ticles being thrown into your eyes, resulting in
possible serious injury.

See Figure 2.

To turn your drill ON, depress the switch trigger. Release
switch trigger to turn your drill OFF.

See Figure 2.

Your drill is equipped with a lock-on feature, which is
convenient when continuous drilling for extended periods
of time is required. To lock-on, depress the switch trigger,
push in and hold the lock-on button located on the side of
the handle, then release switch trigger. Release lock-on
button and your drill will continue running.
To release the lock, depress the switch trigger and release.
If you have the lock-on feature engaged during use and
your drill becomes disconnected from power supply,
disengage the lock-on feature immediately.

See Figure 3.

Your new drill has a keyless chuck. As the name implies,
you can hand tighten or release drill bit in the chuck jaws.
Grasp the chuck collar and rotate it to the left. Release the
collar and then turn the chuck body to the right. The arrows
shown in figure 3 indicate which direction to rotate the
chuck body in order to GRIP (tighten) or RELEASE (unlock)
the drill bit.

Do not hold the chuck body with one hand and
use the power of the drill to tighten  chuck jaws on
drill bit. The chuck body could slip in your hand or
your hand could slip and come in contact with a
rotating drill bit. This could cause an accident
resulting in serious personal injury.

See Figure 4.

Your drill has the feature of being reversible. The direction
of chuck rotation is controlled by a switch located on either
side of the drill housing.

The design of the switch will not permit changing the
direction of rotation while the drill is running. Release the
switch trigger and allow the drill to stop before changing its
direction.

Fig. 2

Fig. 3

Fig. 4