Milan Technology T1E1-CF-01(LH) Manual Do Utilizador

NOTE: KEEP TWISTED-PAIR RUNS AS SHORT AS POSSIBLE. 

•

Locate or build twisted-pair cables  that are compliant with
specifications on page 10.

•

Connect male RJ-45 plug connector at one end of cable to
media converter RJ-45 jack connector.

•

Set MDI/MDI-X switch to MDI-X according to network
conditions.

•

Connect male RJ-45 plug connector at other end of cable to
network equipment..

NOTE: Ground coax segment to earth ground at one end.

•

Locate or build coax cables  that are compliant with
specifications on page 10.

•

Connect BNC connector at one end of cable to media
converter.

•

Connect BNC connector at other end of cable to network
equipment..

•

Locate or build duplex fiber cables that are compliant with
specifications on page 10.

•

Connect male TX and RX cable connectors at one end of cable
to TX and RX female connectors, respectively, on media
converter.

•

Connect male TX and RX cable connectors at other end of
cable to RX and TX connectors of compliant fiber device.

•

Install Power Adapter cord at back of Media Converter.

•

Connect Power Adapter plug to AC power.

•

Verify that Media Converter is powered by observing
illuminated LED(s).

After installation, the media converter should function without operator
intervention. 

Use the status LEDs to
monitor media converter
operation in the network. 

Steady green
LED indicates
connection to
external AC
power.

Signal
Detect/Fiber -
Steady green
LED indicates
fiber link is up.

All Ones Insertion/Fiber - Blinking green LED indicates all ones
received on fiber

Steady green LED indicates coax interface selected.

Signal Detect/Twisted-Pair - Steady green LED indicates
twisted-pair link is up.

All Ones Insertion/Twisted-Pair - Blinking green LED indicates
all ones received on twisted-pair