Grizzly G0619 Manual Do Utilizador
G0619 DELUXE SMALL MILL/DRILL
-25-
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
•
Mill/drill is disconnected from power when not
in use.
in use.
•
Loose mounting bolts.
•
Mill/drill is clean and lubricated.
•
Worn or damaged wires.
•
Any other unsafe condition.
Monthly Check:
•
•
Gibs are adjusted properly.
Annual or Biannual Check:
•
•
Lubricate headstock lead screw and gears.
Schedule
Regular lubrication will ensure your mill/drill per-
forms at its highest potential.
forms at its highest potential.
Place two to three
drops of
a general machine oil directly on the
ways of the cross slide and saddle. An oil bottle
has been provided for this purpose.
has been provided for this purpose.
Nine ball oil-
ers (
Figures 29–31) should be lubricated daily
with several drops of oil.
Protect the unpainted cast iron surfaces with
regular applications of products like G96
regular applications of products like G96
®
Gun
Treatment, SLIPIT
®
, or Boeshield
®
T-9.
Lubrication
Figure 29. Headstock ball oiler locations.
Figure 30. Table and base ball oiler locations.
Figure 31. Table ball oiler location.
One on Each Side