Husqvarna WS 462 Manual Do Utilizador

10 – 

English

The saw carriage is mounted on the rail at delivery.  The 
carriage can be dismounted from the rail by removing the end 
stop on the rail and pulling the carriage away. 

1

Fit the saw body in the saw carriage by lifting the saw body 
into position. When the saw is lifted into position, the 
locking handle moves up into an intermediate position. In 
this position the saw remains in the saw carriage without 
it needing to be held. However, it is not sufficiently secured 
to begin cutting.

For vertical cuts, the rail must be mounted with the saw 
carriage lock handle upwards. This to facilitate fitting the 
saw unit. 

2

To secure the saw, lift the locking handle towards the saw 
until the handle locks.

On the Husqvarna WS 400-series the blade is fitted in an 
entirely new way. The new mounting permits, in addition to the 
tradition way of securing the blade, the possibility to secure 
the blade radially both quickly and easily:

1

Start by removing any dirt from the contact surfaces on 
the blade flange and blade.

2

Check the blade’s direction of rotation. The blade should 
rotate anticlockwise seen from the saw side and the 
released part of the diamond should lie in the blade’s 
direction of rotation.

3

Since the blade rotation direction can be selected, the 
water spray from the blade can also be selected 
regardless of how the saw is turned on the rail.

Screw together the outer blade flange, blade and blade flange 
hub (tightening torque 70-80 Nm).