Multiquip MVC-64H Manual Do Utilizador
l
PAGE 18 — MVC-64H/HW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #5 (03/01/07)
D
1. Place the
fuel valve lever (Figure 11) in the "ON" position.
Figure 11. Fuel Valve Lever
2. Place the
Engine ON/OFF switch (Figure 12) in the "ON"
position.
Figure 12. Engine ON/Off Switch
3. Place the
Choke Lever (Figure 13) in the "OPEN" position.
Nnnn
The CLOSED position of the
choke lever enriches the fuel
mixture for starting a COLD
engine. The OPEN position
provides the correct fuel mixture
for normal operation after
starting, and for restarting a
warm engine.
choke lever enriches the fuel
mixture for starting a COLD
engine. The OPEN position
provides the correct fuel mixture
for normal operation after
starting, and for restarting a
warm engine.
Figure 13. Choke Lever
4. Place the
throttle lever (Figure 14) halfway between fast
and
slow.
Figure 14. Throttle Lever
5. Grasp the starter grip (Figure 15) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding the compression point. Rewind the rope a little from
that point and pull out sharply.
sponding the compression point. Rewind the rope a little from
that point and pull out sharply.
Figure 15. Starter Grip
MVC-64H/HW — INITIAL START-UP
NOTE
DO NOT attempt to operate the plate compactor
until the Safety, General Information and
Inspection sections of this manual have been
read and thoroughly understood.
until the Safety, General Information and
Inspection sections of this manual have been
read and thoroughly understood.
Caution - Read Manual
DO NOT pull the starter rope all the way to the end.
D
O NOT release the starter rope after pulling. Allow it to
rewind as soon as possible.
D
Caution - Starter Rope