Chicago Electric 69452 Manual Do Utilizador

Page 9

Item 69452 

        

1.  Loosen the Chuck with the Chuck Key until the jaws 

of the drill are opened enough to fit the drill bit.

2.  Insert the drill bit (sold separately) all 

the way into the opening and tighten it 

securely in place with the Chuck Key. 

3.  With heavy leather gloves on, tug on the bit to 

make sure it is securely attached. Check that it is 

installed straight in the center of the chuck opening.

note: Use sharp bits. Dull, bent, or damaged bits may 

cause stress on the drill and break causing injury. 

1.  Designate a work area that is clean and well-

lit.  The work area must not allow access by 

children or pets to prevent distraction and injury.

2.  Route the power cord along a safe route to reach 

the work area without creating a tripping hazard or 

exposing the power cord to possible damage.  The 

power cord must reach the work area with enough 

extra length to allow free movement while working.

3.  Secure loose workpieces using a vise or clamps 

(not included) to prevent movement while working.

4.  There must not be objects, such as utility lines, 

nearby that will present a hazard while working.

1.  Plug the Power Cord into a 120V~60Hz outlet.

2.  Slide the Directional Switch to the forward setting.

3.  Place the tip of the drill bit on the workpiece. 

4.  Grasp the handles firmly with both hands 

and slowly squeeze the Trigger. 

5.  To lock the Drill on, press and hold the Trigger 

then press the Lock ON Button. Release the 

Trigger then the Lock ON Button. Press and 

release the Trigger to turn the Drill off.

6.  Allow the bit to cut the hole. 

7.  Remove the bit from the finished hole then release 

the Trigger, or press and release the Trigger if the 

Lock ON Button is engaged. Wait for the Drill to come 

to a complete stop before laying the tool down.

8.  To prevent accidents, turn off the tool and 

disconnect its power supply after use.  Clean, then 

store the tool indoors out of children’s reach.

CautiOn! The bit may be hot to the touch. 

Allow the bit to cool before removing.

note: If a bit becomes wedged into workpiece, 

stop and slide the Directional Switch to the 

reverse setting.  Then slowly squeeze the 

Trigger to back the bit out of the workpiece.

note: When drilling wood, plastic or plastic coated chip 

board, place bit at point to be drilled.  When drilling metal, 

use a punch (sold separately) to mark the drilling position.  

Use a lubricant to the prolong life of bit and increase 

drilling action with most metals. With steel, tin, and sheet 

metal use a light machine oil, with aluminum, use paraffin.  

Do not use lubricants with brass, copper, and cast iron.