Weber 5000 Manual Do Proprietário

Install manifold bracket

You will need:  manifold bracket

Hook the bracket onto the manifold at the center burner
valve. Figure 19. Place your hand underneath the
bracket. Lift the bracket, manifold and cooking box
slightly as a unit and hook onto the frame brace.

Frame brace

Manifold bracket

Install brace panel 

You will need:  brace panel.

Slide the side burner back. Insert the tabs into the slots
in the frame brace at the wheel legs. (Make sure the
side burner hose is to the front of the barbecue.) 
Figure 20 (a). Slide up until the notch at the bottom of
the brace panel fits over the cross brace. Figure 20 (b).

Slot in frame brace

Frame brace

Tabs on 
brace panel

Cross brace

Side burner
hose

Side burner hose

Install right end panel

You will need:  right end panel (Number 3), 1/4-20 x 1 1/2
inch bolt, 1/4-20 hex nut, two nylon washers, 1/4-20 x 1/2
inch bolt, 1/4-20 wing nut and a 7/16 inch wrench.

Set the right end panel over the brace panel. Make sure
the gas supply hose is on the outside of the panel. Put
the washer on the 1/4-20 x 1 1/2 inch bolt and insert bolt
through both panels and frame brace. Add hex nut and
tighten. Figure 21.

Place a nylon washer on the 1/4-20 x 1/2 inch bolt.
Insert the bolt through the top of the right end panel and
the brace panel. Put on wing nut and tighten. Figure 22.