Lincoln Electric IM528-B Manual Do Utilizador

–

12a

–

ELECTRODE

      

-OR-

6 PIN

AMPHENOL

  

K814 ARC START SWITCH

S23732-10      

K870 FOOT AMPTROL

-OR-

K963-1 HAND AMPTROL

 1/03

CAUTION :

 

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE.  IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

THE ENGINE WELDER OPERATING MANUAL.

APPLICATIONS.  SEE OPERATING MANUAL.

N.C.  PLACE WELDER TERMINALS SWITCH TO " REMOTELY CONTROLLED" POSITION.

N.A.  WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

N.D.  PLACE OUTPUT CONTROL SWITCH IN "REMOTE CONTROL" POSITION.

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE  RPM SPECIFICATIONS LISTED IN

N.E.   PLACE IDLER SWITCH IN "HIGH" IDLE POSITION.

N.B.  USE POLARITY SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO A "STICK/WELD" POSITION.

FLOWMETER

K963-3

CONTROL CABLE

Keep guards in place.

Keep away from moving parts.

WARNING

Only qualified personnel should install,use

or service this equipment.

Do not operate with panels open.

Disconnect NEGATIVE (-) BATTERY LEAD

before servicing.

INPUT

REGULATOR

TO GAS

FITTING

Do not touch electrically live parts.

CYLINDER

ARGON GAS

TO WORK