Lincoln Electric K2447-3 Manual Do Utilizador

Página de 39
Python-Plus Owner's Manual - Page 1
Section A  
Installation
Technical Specifi cations
Wire Capacity
.030" - .045" (0.6mm - 1.2mm) solid and hard wire 
.030" - 1/16" (0.8mm - 1.6mm) aluminum and cored wire 
Wire Speed
800 IPM (20.3 mpm) Max. at rated feeder Input Voltage (120VAC / 42VAC)
Duty Cycle - 100% (All ratings are using Argon Gas)
200 Amps/25 Volts
Air cooled standard
Shipping Weight (approximate) - Air Cooled
15ft. (4.5m)....................................... 13.09 lbs. (5.94 Kg)
25ft. (7.6m)....................................... 19.29 lbs. (8.29 Kg)
50ft. (15.2m)..................................... 29.9 lbs. (13.19 Kg)
Torch weight (less leads)
Air/Water cooled - 2.5 lbs.  (1.13 kilogram)
Support Equipment Required
C.V. or C.C. Power Source of suffi cient capacity for your needs.
Regulated gas supply and hoses.
Properly sized power leads from power source to wire feeder and 
ground.
Gun Lead Connections
Power Cable
A #2 AWG power cable is used on the Python-Plus.  The gun end of the 
cable has a fi tting crimped to the copper cable strands.  This fi tting is
then threaded into the gun body.  The cabinet end of the power cable is 
incorporated into the Power/Gas Adaptor.
Conduit
The Python-Plus comes standard with a poly-lined conduit, for feeding 
s
aluminum wire.  The longer fi tting with a shallow groove is used on the gun 
end.  A set screw located on top of the gun handle secures the conduit in 
place. The cabinet end of the conduit is incorporated into the Power/Gas 
Adaptor.
Gas Hose
The gas hose is pushed over a barbed fi tting on the gun body and secured 
with a plastic tie wrap.  The cabinet end of the gas hose is incorporated into 
the Power/Gas Adaptor.
Electric Cable
A multi-conductor control cable is used on the Python-Plus.  The gun end of 
the cable is secured with a cable clamp and the wires are connected to the 
potentiometer, the micro switch, the motor and the gun body mechanically. 
Slack is left in the electric cable as it exits the back of the gun to prevent 
cable and/or wire breakage.  The cabinet end of the control cable uses a 
7-Pin, Amphenol connector.