Python 248-8XX Manual Do Utilizador

 Owner's Manual - Page 1

Aluminum or Cored Wire ..............................

Solid and Hard Wire .....................................

Wire Speed (At rated feeder input voltage) .................... 800 ipm (20.3 mpm)
Duty Cycle - 60% (All ratings are using Argon gas) ........................400 Amps 
Shipping Weight (approximate) ...................................... 19.29 lbs. (8.29 Kg)

•

  C.V. or C.C. power source of sufficient capacity for your needs.

•

  Regulated gas supply and hoses.

•

  Properly sized power leads from power source to wire feeder and 

ground.

Millermatic Compatible™ Python

®

 liquid cooled guns utilize a specially 

designed cable with a #6 AWG cable inside a 1/2" (13 mm) diameter hose. 

Liquid coolant is used with this cable and the #10 liquid cooled gas cup, 

the system is rated at 400 amps @ 60% duty cycle. The welding power 

connection is incorporated through the power pin type connector.
The power cable ends are threaded fittings which screw into the gun body 

and the power pin connector. These connections utilize a conductive sealant 

and are tightened with torque requirements of 100 + 5 IN-LB. 
Conduit 

The liquid cooled Millermatic Compatible™ Python

®

 comes standard with 

a poly-lined conduit, for feeding aluminum wire.  The longer fitting with a 

shallow groove is used on the gun end.  A set screw located on top of the 

gun handle secures the conduit in place. The cabinet end of the conduit is 

secured into the Power Pin connector with a set screw.
Gas Hose

The gas hose is pushed over barbed fittings on both gun body and the Power 

Pin connector and is secured with a plastic tie wrap.  
Coolant Connections 

The blue coolant (supply) hose is pushed over a barbed fitting on the gun 

body and secured with a plastic tie wrap. The red coolant (return) hose 

connects through the power cable and the power pin connector.
Both hose fittings are standard coolant style, left-hand threads.
Control Cable

A multi-conductor control cable is used on the liquid cooled Millermatic 

Compatible™ Python

®

.  The gun end of the cable is secured with a cable 

clamp and the wires are connected to the potentiometer, the micro switch, 

the motor and the gun body mechanically.  Slack is left in the electric cable 

as it exits the back of the gun to prevent cable and/or wire breakage.  The 

cabinet end of the control cable uses a 10-Pin, "X" clocked connector.