IBM 9077 Manual Do Utilizador
Installation and Configuration
70
The intent of this chapter is to provide, or refer you to, the necessary
information to enable you to attach an SP Switch Router to an IBM SP
system. Coverage is provided as follows:
information to enable you to attach an SP Switch Router to an IBM SP
system. Coverage is provided as follows:
• Information to configure the SP Switch Router Adapter card as required
for SP Switch Router functionality is complete in this chapter.
• Information to physically connect the two independent systems across
cables is complete in this chapter.
• Information to start up, configure, and begin operations on the SP Switch
Router is contained in
GRF 400/1600 Getting Started
1.4, GA22-7368.
• Information to configure the SP Switch Router Adapter card as required
for SP system functionality is only partially described in this chapter.
Detailed information is contained in the "Managing Extension Nodes"
chapter in
Detailed information is contained in the "Managing Extension Nodes"
chapter in
RS/6000 SP: Administration Guide Version 2 Release 4,
GC23-
3897.
3.1 Initial Configuration
When a new, unconfigured GRF is powered on an initial configuration script
runs automatically. You will be asked a series of questions about the
configuration, as shown in the following screen.
runs automatically. You will be asked a series of questions about the
configuration, as shown in the following screen.
Next you are prompted to change the local password for root.Changing the
root password is the end of the configuration script. If you need to change
these parameters later, run the config_netstat script again. More details about
the initial configuration are in
root password is the end of the configuration script. If you need to change
these parameters later, run the config_netstat script again. More details about
the initial configuration are in
GRF Configuration Guide 1.4
, GA22-7366.
If you log onto the GRF, a
super>
prompt appears. This indicates that you are
in the command-line interface (CLI). This CLI is different compared to other
Welcome to Ascend Embedded/OS system configuration..
Host name for this machine ?
Do you wish to configure the maintenance Ethernet interface ?
Which interface type ? (TP BNC AUI)
IP address of this machine ?
Netmask for this network ?
IP address of router (‘none’ for no default route)?
Do you wish to go through the questions again ?
Which region is this machine located in ?
Which time zone ?
Do you wish to configure the maintenance Ethernet interface ?
Which interface type ? (TP BNC AUI)
IP address of this machine ?
Netmask for this network ?
IP address of router (‘none’ for no default route)?
Do you wish to go through the questions again ?
Which region is this machine located in ?
Which time zone ?