KYOCERA FS-C5300DN Manual Do Utilizador

Using the Operation Panel 

6-23

In private printing, you can specify that a job is not printed until you 
release the job from the operation panel. When sending the job from the 
application software, specify a 4-digit access code in the printer driver. 
The job is released for printing by entering the access code on the 
operation panel ensuring confidentiality of the print job.

In the stored job mode, access codes are not mandatory, but can be set 
on the printer driver if printing with PIN security is required. Then, the 
access code must be entered on the operation panel to print a stored job. 
Print data will be stored in the hard disk/RAM disk after printing. 

Refer to KX Printer Driver User Guide for the driver settings.

1

Press 

Z while Job Box > is displayed.

2

Press 

U or V repeatedly until >Private/Stored appears. The 

name entered in the printer driver (

Harold, in this example) also 

appears.

3

Press [OK]. A blinking question mark (

?) appears before the user 

name.

4

Press 

U or V to display the desired user name (Arlen, in this 

example).

5

Press [OK]. The user name and the job name (

Agenda, in this 

example) entered in the printer driver appear with a blinking question 
mark (

?).

6

Press 

U or V to display the desired job title. 

7

Press [OK]. The ID input line appears. Enter the four-digit access 
code entered in the printer driver and press [OK]. 

To enter the ID, press 

Y or Z to move the cursor to the number to be 

changed and then enter the correct number by pressing 

U or V.

8

You can set the number of copies to be printed. To increase the copy 
count, press 

U; to decrease the copy count, press V.

9

Press [OK] to finalize the copy count. The printer prints the specified 
number of copies for the job.

>Private/Stored
?Harold

>Arlen
?Agenda

>Agenda
 ID         0000

>Agenda
 Copies      001