Ricoh SP C250SF Manual Do Utilizador

Problem

Solution

Multiple sheets of paper are fed at
once.

• Fan the paper well before loading. Also make sure that

the edges are aligned by tapping the stack on a flat
surface such as a desk.

• Make sure that the paper guides are in the right position.
• Use supported types of paper. See page 57 "Supported

• Load paper only as high as the upper limit markings on

the paper guide.

• Make sure that the friction pads, paper feed rollers or

• Check that paper was not added while there was still

some left in the tray.
Only add paper when there is none left in the tray.

The printed paper is wrinkled.

• The paper being used may be damp. Use paper that has

• Paper is too thin. See page 57 "Supported Paper".
• If there are gaps between the paper and the paper

guides, adjust the paper guides to remove the gaps.

• Check that both the left and right fusing unit levers have

been raised to the plain paper mark.

The printed paper is curled.

• Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output

tray more frequently.

• The paper being used may be damp. Use paper that has

• Select [Lvl.2: Medium] or [Lvl.3: Strong] in [Anti-Humidity

Level] under [System Settings]. Note that if you select [Lvl.
2: Medium] or [Lvl.3: Strong], the first print takes longer
than subsequent prints.

Paper Feed Problems

307