Sharp AR-M205 Manual Do Utilizador

INTERRUPTING A COPY RUN

(Interrupt copying)

A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.

Press the [INTERRUPT] key (

) to

interrupt the copy run.

The INTERRUPT
indicator will light up and
the machine will revert to
the initial settings. (p.12)
The INTERRUPT
indicator will blink until
the current copy run
stops.

Remove the previous original(s) and
place the original(s) of the interrupt
copy job.

Set the number of copies and other
copy settings and then press the
[START] key (

The copy will be
delivered to the paper
output tray slightly offset
from the copies of the
interrupted run. (Offset
function)
The offset function can
be disabled in the user
programs. (p.45)

A: Copies made before the interrupt copy job
B: Interrupt copy job
C: Copies made after the interrupt copy job

When the copy job is finished, press
the [INTERRUPT] key (

) and remove

the original(s).

The INTERRUPT indicator will go off, indicating
that the interrupt function is no longer operating.
The copy settings will automatically revert to the
settings selected for the copy run before the run
was interrupted.

Replace the previous original(s) and
press the [START] key (

The interrupted copy run will resume.

Interrupt copying is not possible when the user programs are being configured, or when automatic two-sided
copying, sort/group copying, or 2 IN 1 / 4 IN 1 copying is being performed.

Note

• If the SPF/RSPF is being used, the copy

run will not stop until the set number of
copies is completed.

• If "Auditing mode" is enabled:

"- - -" will appear in the number of copies
display. Enter your 3-digit account number.
Copying will not be possible unless a
correct account number is entered. (p.51)

INTERRUPT

Note