Sharp FO-DC500 Manual Do Utilizador
Timer Operations
158
Timer Operations
The Timer function allows you to store a fax job to be performed automatically
at a specified time. Up to 59 timer jobs can be stored at any one time, and the
time of each can be specified up to a week in advance.
at a specified time. Up to 59 timer jobs can be stored at any one time, and the
time of each can be specified up to a week in advance.
You can use this function to take advantage of lower off-peak rates without
having to be there when the operation is performed.
having to be there when the operation is performed.
♦
The timer function cannot be used for e-mail transmissions.
♦
The DOCUMENT key cannot be used for a timer transmission.
Initial procedure
To store a timer job, first perform the following procedure. After you have
completed this procedure, go to the procedure for the specific job you want to
store (see the following pages).
completed this procedure, go to the procedure for the specific job you want to
store (see the following pages).
1
Press
. (Flip up the Rapid Key
overlay if it is down.)
2
Make sure that “SET” is selected and
then press
.
3
Press
or
to select the desired operation and then press
).
Note: “CONFIDENTIAL TX MODE” stands for “confidential transmission
mode”.
mode”.
4
Enter a two-digit number for the hour (“01” to “12”) and a two-digit
number for the minute (“00” to “59”).
number for the minute (“00” to “59”).
TIMER
X/>
START/
ENTER
ENTER
START/
ENTER
ENTER
Display:
TIMER MODE
1=SET
2=CLEAR
2=CLEAR
TIMER SET
1:SEND MODE
2:BROADCAST MODE
3:CONFIDENTIAL TX MODE
4:POLLING MODE
5:SERIAL POLLING MODE
2:BROADCAST MODE
3:CONFIDENTIAL TX MODE
4:POLLING MODE
5:SERIAL POLLING MODE