Toshiba e-STUDIO195 Manual Do Utilizador

Before Calling Service Technician    199

An original jams.

An original not acceptable for 
the equipment is being used.

Check if the original is acceptable for the 
equipment.

Copy paper jams.

Copy paper not acceptable 
for the equipment is being 
used.

Check if the copy paper is acceptable for 
the equipment. 

The size of the copy paper in 
the drawer or on the bypass 
tray is not registered prop-
erly in the equipment. 

Register the size of the placed copy paper 
properly. 

of Paper Placed”

Jammed paper is located in 
a place you cannot see eas-
ily.

See the message on the display to 
recheck the position where the paper jam 
has occurred.

There is no gap between the 
side guides and paper in the 
drawer. Or the gap is too 
wide.

Adjust the gap between the side guides 
and the paper properly.

There is a gap between the 
paper and the end guide in 
the drawer.

Do not allow any gap between the paper 
and the end guide in the drawer.

Multiple feeding occurs.

Paper is clinging to each 
other.

Fan the paper well and place it again.

The density of the copy 
image is light.

Toner has run out.

“Toner empty” appears on the display 
when toner has run out. Replace the toner 
cartridge if the message appears.

The copy density is set 
lighter.

Make the density darker if you use the 
manual copy density mode. Or use the 
automatic copy density mode.

The transfer charger wire is 
dirty.

Clean the transfer charger wire.

The density of the copy 
image is dark.

The copy density is set 
darker.

Make the density lighter if you use the 
manual copy density mode. Or use the 
automatic copy density mode.