Motorola LS9203 Manual Do Utilizador

9-5

This chapter describes all symbology features and provides the programming bar codes necessary for selecting these features for the 
Symbol  LS9203 scanner. Before programming, follow the instructions in 

.

The scanner is shipped with the settings shown in the 

 (also see 

 for all host device and miscellaneous scanner defaults). If the default values suit your requirements, programming may 

not be necessary. Features values are set by scanning single bar codes or short bar code sequences.

To return all features to their default values, scan the 

If using a USB cable, select a host type. Refer to each host chapter for specific host information.

In most cases only scan one bar code to set a specific parameter value. For example, to transmit bar code data without the UPC-A 
check digit, simply scan the 

 bar code listed under 

. The scanner issues a short high beep and the LED turns green, signifying a successful parameter entry.

Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in the proper sequence. Refer to the 
individual parameter, like Set Length(s) for D 2 of 5, for this procedure.

Unless otherwise specified, if an error is made during a scanning sequence, just re-scan the correct parameter.