Franklin DBD-4028DL Manual Do Utilizador
Installing BOOKMAN Cards
1. Turn your product off.
2. Turn your product over.
3. Align the tabs on the card with the notches in the slot.
2. Turn your product over.
3. Align the tabs on the card with the notches in the slot.
4. Press the card down until it snaps into place.
✓
Removing Cards
Warning: Never install or remove a BOOKMAN card while your product is on. Any
information that was entered in the built-in book or card will be erased.
information that was entered in the built-in book or card will be erased.
✓
BOOKMAN Card Troubleshooting
Make sure your BOOKMAN card is installed correctly. If your card is performing erratically, fol-
low the reset instructions in “Resetting Your Product”. If this does not fix the problem, remove
the card and then remove the white rubber strip located between the two metal pins. Clean
the rubber strip with your fingers and then replace it making sure it is completely in its notch.
low the reset instructions in “Resetting Your Product”. If this does not fix the problem, remove
the card and then remove the white rubber strip located between the two metal pins. Clean
the rubber strip with your fingers and then replace it making sure it is completely in its notch.