Yamaha DSP5D Manual Do Utilizador

Here you can make settings that apply to the entire PM5D 
system.

A +48V MASTER (DSP5D only)

This is the master phantom power (+48V) switch for 
INPUT jacks 1–48 and ST IN jacks 1–4. If this switch is 
off, the +48V button shown in the display will be 
disabled.

B VIRTUAL SOUNDCHECK

This temporarily switches the input signals without 
affecting the scene memory (input patching). For 
example, this allows you to perform a sound check 
using pre-recorded material played back by a DAW 
connected to a slot, instead of the analog input mate-
rial received via the INPUT jacks. When you click the 

 button located at the left, the VIRTUAL SOUND-

CHECK SETUP window will appear, allowing you to 
assign a replacement port for each port. To enable 
these settings, click the ON/OFF button located at the 
right.

For each port, you can specify a port that will be substi-
tuted virtually. You cannot assign the same port to more 
than one port. If you assign a previously-assigned port 
to a different port, the patch will be turned off (shown in 

gray) for the port whose assignment was taken away. If a 
slot is exchanged with the CASCADE IN connector, the 
cascade bus number will be displayed in black on a yel-
low background in the slot port number display area. In 
the example shown above, slots 1 and 2 are assigned to 
AD IN 1–32, so you’ll be able to perform a sound check 
using pre-recorded audio received at slots 1 and 2 
instead of the analog inputs to the INPUT jacks.
By clicking the PRESET button, you can return the set-
tings of the VIRTUAL SOUNDCHECK SETUP 
window to their factory-set state.

C PAIR MODE

Select one of the following two methods by which 
input channels will be paired.

If this button is on, input channels of adjacent num-
bers (1/2, 3/4 ...) will be paired.

If this button is on, input channels of different layers 
that share the same fader (1/25, 2/26 ...) will be paired. 
This setting lets you use the faders of the INPUT chan-
nel strip to control up to 24 pairs (48 channels).

When you switch from horizontal pair mode to verti-
cal pair mode, new numbers will be assigned to the 
input channels as follows.

Channel 1 

→ no change

Channel 2 

→ Channel 25

Channel 3 

→ Channel 2

Channel 4 

→ Channel 26

                       :

Channel 47 

→ Channel 24

Channel 48 

→ no change

(If you again switch back to horizontal pair mode, the 
channels will return to their previous number.) How-
ever, please note that this simply means the input 
channel that was previously called “channel 2” is now 
called “channel 25”; the name and parameter settings 
of that channel have not changed.
In the various screens of the display (except for the 
TRACKING RECALL screen and the FADER VIEW 
screen), switching the pair mode will only change the 
displayed numbers; the arrangement of the input chan-
nels will not change.

D PAN NOMINAL POSITION

Here you can specify whether a signal will be at nomi-
nal level when panned to center, or at nominal level 
when panned far left or far right. Choose one of the fol-
lowing two settings. You can choose independently for 
monaural channels and paired channels.

The signal will be at nominal level (+0 dB) when 
panned to the center, and will rise +3 dB when panned 
to far left or far right.

↔ R

The signal will be at nominal level (+0 dB) when 
panned to far left or far right, and will decrease 
–3 dB when panned to the center.

1

3

2

4