Yamaha DSP5D Manual Do Utilizador

D Meters

These peak level meters indicate the input level of each 
channel. The current fader value is shown in the box 
below.
If clipping occurs at any point PRE ATT, POST EQ, 
POST GATE, POST COMP, INSERT IN, or POST 
FADER, the 

∑ segment will light.

E Pair icon

This indicates the pairing status of two adjacent odd-
numbered/even-numbered channels.

This screen contains meters that show the output level of 
output channels (MIX channels 1–24, MATRIX channels 
1–8, STEREO A/B channels), MONITOR (L/R/C), and 
CUE (L/R).

A METERING POINT

Select one of the following as the point at which the 
output level will be detected.

PRE EQ  . . . . . . . . . .  Immediately before the EQ
PRE FADER  . . . . . .  Immediately before the fader
POST FADER . . . . .  Immediately after the fader
POST ON  . . . . . . . .  Immediately after the [ON] key
POST DELAY . . . . .  Immediately after the internal 

delay (of an output channel)

B CUE METERING POINT

Select one of the following as the point at which the 
output level of the cue signal will be detected.

PRE DELAY  . . . . . .  Immediately before the internal 

delay (of a monitor/cue 
channel)

POST DELAY . . . . .  Immediately after the internal 

delay (of a monitor/cue 
channel)

C PEAK HOLD

If this button is on, the peak level of each meter will be 
held. When you turn this button off, the peak level 
indication that had been held will be cleared. Peak hold 
will be cleared when you change the metering point 
(

1

). This button is linked with the [PEAK HOLD] key 

in the METER section of the top panel.

4

5

1

2

3