Yamaha DSP5D Manual Do Utilizador

Here you can make settings for LCR mode, which allows 
three-channel playback by adding a CENTER channel to 
the L/R channels of the STEREO bus. This function can be 
used only with MIX channels.

A Response graph

These graphs indicate the approximate LCR response 
for each MIX channel. The graph will change as the 
CSR knob (

2

) is edited.

B CSR (Center Side Ratio)

This knob adjusts the proportional level of the CEN-
TER channel relative to the L/R channels. The range is 
0–100%.
If the CSR knob is set to 0%, turning the PAN knob in 
the MIX TO STEREO area of the MATRIX/ST ROUT-
ING screen (or the [PAN] encoder in the SELECTED 
CHANNEL section) will change the signal levels of the 
L/R channels as shown below.

In this case, MIX TO STEREO PAN will operate as a 
conventional PAN control, and no signal will be sent to 
the CENTER channel.

If CSR is set to 100%, turning the PAN knob ([PAN] 
encoder) will change the signal levels of the L/R chan-
nels as shown below.

When the PAN knob ([PAN] encoder) is in the center 
position, the signal level of the CENTER channel will 
be at maximum, and no signal will be sent to the L/R 
channels.

C LCR (LCR mode on/off)

For each MIX channel, this turns LCR mode on/off.
For channels where LCR mode is turned on, the PAN 
knob in the MIX TO STEREO area of the MATRIX/ST 
ROUTING screen can be used to simultaneously con-
trol the levels of the L/R channels and the CENTER 
channel.
If you have selected a MIX channel for which LCR is 
on, you can also use the [PAN] encoder in the 
SELECTED CHANNEL section of the top panel. In 
this case, the peripheral LEDs will change as follows 
when you operate the [PAN] encoder.

➥ p.222). Be aware that when this but-

3

1

2

4

C

R

L

Signal sent to the 
R channel

[PAN] encoder

Signal sent to the 
L channel

Signal le

v

e

l

C

R

L

[PAN] encoder

Signal sent to the 
R channel

Signal sent to the 
C channel

Signal sent to the 
L channel

Signal le

v

e

l