Yamaha DSP5D Manual Do Utilizador

INPUT jacks 1–48 are used mainly to connect micro-
phones or monaural line-level devices. ST IN jacks 1–4 are 
used mainly to connect stereo line-level devices.
Input signal sensitivity, pad on/off, and phantom power 
(+48V) on/off are controlled from the top panel AD IN 
section (

➥ p.44).

INPUT jacks 1–48 and ST IN jacks 1–4 can both be used to 
connect microphones or line-level devices.
Input signal sensitivity and phantom power (+48V) on/off 
are controlled from within the display (

➥ p.44). However, 

all phantom power can be switched on/off as a whole by 
the rear panel [+48V MASTER] switch.

INPUT jacks 1–48 and ST IN jacks 1–4 will accommodate 
connections ranging from microphones to line level 
devices.
Each connector is provided with phantom power (+48V), 
and the input signal sensitivity and phantom power on/off 
can be operated from the display as on the PM5D-RH 
(

➥ p.44). The +48V master switch is turned on/off in the 

SYS/W.CLOCK function MIXER SETUP screen 
(

➥ p.221).

Synthesizer

Microphone

Effect processor

Synthesizer

Microphone

Microphone

When the PM5D, PM5D-RH, or DSP5D are in the 
default state, the input signal from INPUT jacks 1–48 is 
patched to input channels 1–48, and the input signal 
from ST IN jacks 1–4 is patched to the ST IN channels. 
However, you may change this if desired (for details on 
restoring the default patching 

➥ p.40).

Synthesizer

Microphone