Viewsonic Z50 Manual Do Utilizador
E
N
G
N
G
L
I
S
H
H
4
Optiquest
Z50
Quick Installation
1 Connect video cable
Make sure both the monitor and computer
are powered OFF.
are powered OFF.
Connect the video cable to the computer.
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter.
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter.
To order a Macintosh adapter, contact
ViewSonic
ViewSonic
®
. See “Customer Support” on
page 12.
2 Connect power cord
Connect the power cord from the monitor to
a properly grounded AC outlet.
a properly grounded AC outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
computer. This sequence (monitor before
computer) is very important.
NOTE:
At this point Windows 98 users may
receive a message asking them to install the
Z50 INF file.
Z50 INF file.
4 Install INF and ICM files
For CD-ROM: Insert your CD-ROM, select
“Monitor Drivers,” and follow the on-screen
instructions.
“Monitor Drivers,” and follow the on-screen
instructions.
For diskette: Insert your diskette and run
install.exe.
install.exe.
Follow the on-screen
instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh
rate)
rate)
Example: 800 X 600 @ 75Hz.
For instructions on changing the resolution
and refresh rate, see the user guide for your
computer's graphics card.
and refresh rate, see the user guide for your
computer's graphics card.
Installation is complete. Enjoy your new
Z50 monitor!
Z50 monitor!
To be best prepared for any future customer
service needs:
service needs:
Write the serial number (see back of the
monitor) in “For your Records” on page 2 of
this guide.
monitor) in “For your Records” on page 2 of
this guide.
Register the warranty of your monitor on the
Internet at:
Internet at:
www.viewsonic.com
AC Outlet
Video Cable
Power Cords