IBM 21L4364 Manual Do Utilizador

2.

Carefully insert the head of a flathead (–) screwdriver into the slot visible 

along either side of the cable cover (a) and pry it off.

3.

Squeeze the sides of the hinge cover (b) and pull it off.

4.

Gently lift the stand cover (c) along the top and then slide it backwards 

and off the stand.

5.

Remove the signal cable and the power cord from the monitor by 

disconnecting the corresponding adapters. Carefully cut the plastic tie to 

free the power cord and remove the screw holding the power cord 

clamp. 

6.

Lay the monitor facedown on a cushion and remove the six screws 

holding the hinge mechanism on the monitor. Lift off the hinge and base 

assembly.

7.

Insert the head of a flathead (–) screwdriver in the slot of one of the two 

VESA caps (d) and pry the cap off. Repeat the procedure on the other 

VESA cap.

8.

If you are installing an arm or wall-mounting device, follow the directions 

included with the device. If you are just changing your cables, continue 

with Step 9.

9.

Connect the signal cable and the power cord, then refit the power cord 

clamp in its original screwpost.

10. Slide the stand cover back on the stand.