IBM 150P Manual Do Utilizador

To set up the monitor automatically in Windows 95, Windows 98,        
Windows NT,  Windows 2000, Windows Me, or Windows XP, do the following:

1.

Turn on the monitor first; then the computer.

If the message 

CHECK SIGNAL CABLE

 is displayed, or if nothing is 

displayed, check:

• that the video interface cable is connected properly.
• the correct video adapter card is installed.
• the correct supported display mode is selected for your computer.

2.

Wait approximately 15 minutes, until the monitor warms up.

3.

Drag the icon bar and tool bar, if they are displayed, to the bottom of the 
screen.

4. 

Insert the User's Guide and Installation CD into the computer CD-
ROM drive.

5.

Check the operating system installed on your computer and follow the 
instructions from the table below.

6.

When the test pattern appears, press the Image Setup (

) button  at 

the bottom of the monitor.  This activates the 

A

UTO

 S

ETUP

 procedure, 

which will optimize the display settings with the provided test patterns.
The screen will momentarily turn black while auto adjustment proceeds. 

7.

When finished, the Auto Adjustment menu disappears and the screen 
returns to a normal display.

8.

Press the 

E

SC

 key to return to Windows.

You have completed the monitor setup for Windows. If you are using the DOS 
operating system, go to 

 on page 14.

Windows 95,
Windows 98,
Windows 2000,
Windows NT,
Windows Me or
Windows XP

Select 
S

Select 

Type 

:\TESTPAT (change 

the drive letter to match your 

CD-ROM drive if it is not drive 

D) and press ENTER

L170_E.fm  Page 13  Tuesday, February 11, 2003  12:51 AM