Philips S1D13505 Manual Do Utilizador

Page 8

Epson Research and Development

Vancouver Design Center

S1D13505

S5U13505B00C Rev. 1.0 ISA Bus Evaluation Board User Manual

X23A-G-004-05

Issue Date: 01/02/05

2 Installation and Configuration

The S1D13505 has 16 configuration inputs MD[15:0] which are read on the rising edge of RESET#.
Inputs MD[5:1] are fully configurable on this evaluation board for different host bus selections; one
eight-position DIP switch is provided for this purpose. All remaining configuration inputs are hard-
wired. See the S1D13505 Hardware Functional Specification, document number X23A-A-001-xx
for more information.

The following settings are recommended when using the S5U13505B00C with the ISA bus.

Note

JP1 is for internal use only, default setting is 1-2.

Table 2-1: Configuration DIP Switch Settings

Switch Signal

Closed (1)

Open (0)

SW1-1 MD1

See “Host Bus Selection” table below

SW1-2 MD2

SW1-3 MD3

SW1-4 MD4

Little Endian

Big Endian

SW1-5 MD5

Wait# signal is active high

Wait# signal is active low

SW1-6 MD13

Reserved

SW1-7 MD14

SW1-8 MD15

Table 2-2: Host Bus Selection

MD3 / SW1-3

MD2 / SW1-2

MD1 / SW1-1

Host Bus Interface

open (0)

SH-3/SH-4 bus interface

open (0)

closed (1)

MC68K bus 1 interface (e.g. MC68000)

open (0)

closed (1)

open (0)

MC68K bus 2 interface (e.g. MC68030)

open (0)

closed (1)

Generic bus interface

closed (1)

open (0)

Reserved

closed (1)

open (0)

closed (1)

MIPS/ISA

closed (1)

open (0)

PowerPC

closed (1)

PC Card (PCMCIA)

= recommended settings (configured for ISA bus support)

Table 2-3: Jumper Settings

Description

1-2

2-3

JP1

DRDY (pin 76, S1D13505)

Pin 76 connected to J6 pin 38

Pin 76 connected to J6 pin 35

JP2

LCD V

Selection

5.0V

LCD driver V

3.3V

LCD driver V