Fujitsu MPC3065AH Manual Do Utilizador
C141-E056-02EN
6 - 10
When one of following commands is issued, the command is executed normally and the
device is still stayed in the standby mode.
device is still stayed in the standby mode.
•
Reset (hardware or software)
•
STANDBY command
•
STANDBY IMMEDIATE command
•
A command without accessing the drive
•
CHECK POWER MODE command
(4)
Sleep mode
The power consumption of the drive is minimal in this mode. The drive enters only the
standby mode from the sleep mode. The only method to return from the standby mode is to
execute a software or hardware reset.
standby mode from the sleep mode. The only method to return from the standby mode is to
execute a software or hardware reset.
The drive enters the sleep mode under the following condition:
•
A SLEEP command is issued.
Issued commands are invalid (ignored) in this mode.
6.3.2
Power commands
The following commands are available as power commands.
•
IDLE
•
IDLE IMMEDIATE
•
STANDBY
•
STANDBY IMMEDIATE
•
SLEEP
•
CHECK POWER MODE
6.4
Defect Management
Defective sectors of which the medium defect location is registered in the system space are
replaced with spare sectors in the formatting at the factory shipment.
replaced with spare sectors in the formatting at the factory shipment.
All the user space area are formatted at shipment from the factory based on the default
parameters listed in Table 6.1.
parameters listed in Table 6.1.