Toshiba SR-M8102 Manual Do Utilizador

  

3 

 
The following steps must be performed to properly install your drive:  

•  Set Drive Jumper Settings 
•  Connect Audio Cable 
•  Attach IDE BUS Cable 
•  Attach Power Cable 
•  Mount Drive 
 

Jumper Settings 
The mode select jumpers are 6 straight angle pins located on the rear of the CD-R/CD-RW drive.  
By placing a jumper on the pins, you can select the following functions: 
 

 
 
CS 

 
 
Drive is configured using host interface signal CSEL 

SL 

Configures drive as Slave 

 

MA 

Configures drive as Master (default mode) 

Figure 1.Mode Select Jumper 

 
In most installations, jumper should remain in the MA position (factory default). It is recommended that 
you install your CD-R/CD-RW drive only on the secondary IDE BUS. If you are installing on primary IDE 
BUS, your hard drive would then be the Master, and you should set your CD-R/CD-RW drive to the 
Slave position (SL) 

                      Figure 2.Jumper Locations