Toshiba XM-6802B Manual Do Utilizador
3
SETUP – XM-6802B CD-ROM
The following steps must be performed to properly install your drive:
• Set CD-ROM Drive Jumper Settings
• Connect Audio Cable (optional)
• Attach IDE BUS Cable
• Attach Power Cable
• Mount Drive
• Connect Audio Cable (optional)
• Attach IDE BUS Cable
• Attach Power Cable
• Mount Drive
Jumper Settings
The mode select jumpers are 6 straight angle pins located on the rear of the CD-ROM drive.
By placing a jumper on the pins, you can select the following functions:
By placing a jumper on the pins, you can select the following functions:
CS
Drive is configured using host interface signal CSEL
SL
Configures drive as Slave
MA
Configures drive as Master (default mode)
Figure 1.Mode Select Jumper
In most installations, jumper should remain in the MA position (factory default). It is recommended that
you install your CD-ROM drive only on the secondary IDE BUS. If you are installing on primary IDE BUS,
your hard drive would then be the Master, and you should set your CD-ROM drive to the Slave position
(SL)
you install your CD-ROM drive only on the secondary IDE BUS. If you are installing on primary IDE BUS,
your hard drive would then be the Master, and you should set your CD-ROM drive to the Slave position
(SL)
Figure 2.Jumper Locations