Toshiba 4006GAH Manual Do Utilizador
Toshiba Corporation Digital Media Network Company
Page 53 of 157
© 2005, Copyright TOSHIBA Corporation All Rights Reserved
10.7.2.2 Diagnostic Mode
The drive enters diagnostic mode immediately after the power -on or after an Execute Diagnostics
command. Error bit in Status Register shall not be set in these cases. The following table shows bit values
for the diagnostic mode.
command. Error bit in Status Register shall not be set in these cases. The following table shows bit values
for the diagnostic mode.
Table 10.7-1 Diagnostic mode error register
01 No
errors
02
Controller register error
03
Buffer RAM error
04
ECC device error
05
CPU ROM/RAM error
06-7F Reserved
8x
8x
Drive1 error (see below)
When two drives are daisy-chained on the interface, the Drive0 has valid error information for diagnostic
mode. When the Drive1 detects an error, 80H and OR value (01∼04) diagnosed by the Drive0 are set to
the code above mentioned.
mode. When the Drive1 detects an error, 80H and OR value (01∼04) diagnosed by the Drive0 are set to
the code above mentioned.
10.7.3 Features Register (Write Precompensation Register)
- CS0
DA2-DA0 : 1
Write only
Write precompensation is automatically optimized by the drive internally. This register is used with Set
Features command.
Features command.
10.7.3.1 Smart command
This command is used with the Smart commands to select subcommands.
10.7.4 Sector Count Register
- CS0
DA2-DA0 : 2
Read / Write
10.7.4.1 Disk Access command
The sector count register determines the number of sectors to be read or written for Read, Write, and Verify
commands. A 0 in the sector count register specifies a 256 sector transfer. After normal completion of a
command, the content shall be 0.
commands. A 0 in the sector count register specifies a 256 sector transfer. After normal completion of a
command, the content shall be 0.
During a multi-sector operation, the sector count is decremented and the sector number is incremented. If
an error should occur during multi-sector operation, this command shows the number of remaining sectors
in order to avoid duplicated transfer.
an error should occur during multi-sector operation, this command shows the number of remaining sectors
in order to avoid duplicated transfer.
10.7.4.2 Initialize Device Parameters command
This register determines number of sectors per track.
10.7.4.3 Power Control command
This register returns a value in accordance with the operation mode (idle mode or stand-by mode).
10.7.4.4 Set Features Command
If features register for this command is 03h, this register sets the data transfer mode.