National Instruments 321042A-01 Manual Do Utilizador
Hardware Configuration and Installation
Chapter 2
STD-GPIB for Windows
2-4
© National Instruments Corp.
Configure the Hardware
Follow the instructions in this section to change the hardware settings of the STD -GPIB
before you install it. The default settings are suitable for most STD systems, but you
need to change the hardware settings in the following situations:
before you install it. The default settings are suitable for most STD systems, but you
need to change the hardware settings in the following situations:
•
If you want to use interrupts for the STD-GPIB
•
If the default settings conflict with another device in your system
•
If you are installing more than one STD-GPIB
The default settings for the switches and jumpers on the STD-GPIB are as follows:
•
Base I/O Address (hex ): 2C0
•
DMA Channel: 5
•
Interrupt Line (IRQ): None