Connect Tech CTIM-00043 Manual Do Utilizador
CANpro/104 User Manual
17
www.connecttech.com
CTIM-00043 (0.01) 1/15/2010
800-426-8979 | 519-836-1291
J3B
Position
Function
Jumper Installed
Jumper Removed
1
Mem Addr[16] or I/O Addr[9] = 1
Mem Addr[16] or I/O Addr[9] = 0
2
Mem Addr[15] or I/O Addr[8] = 1
Mem Addr[15] or I/O Addr[8] = 0
3
Mem Addr[14] = 1
or
I/O Addr[7] = 1 (BasicCAN mode only)
Mem Addr[14] = 0
or
I/O Addr[7] = 0 (BasicCAN mode only)
4
Mem Addr[13] = 1
or
I/O Addr[6] = 1 (BasicCAN mode only)
Mem Addr[13] = 0
or
I/O Addr[6] = 0 (BasicCAN mode only)
5
Memory Space Enable Bit-2 [Note 1]
6
Memory Space Enable Bit-1 [Note 1]
7
Memory Space Enable Bit-0 [Note 1]
Table 21
The 3 Memory Space Enable bits select 8 choices of I/O Addresses for the Memory Enable feature.
The 3 Memory Space Enable bits select 8 choices of I/O Addresses for the Memory Enable feature.
J3C
Position
Function
Jumper Installed
Jumper Removed
1
Memory Space powers-up (or resets)
disabled
Memory Space is always enabled
2
BasicCAN mode enabled
PeliCAN mode enabled
3
CAN-1 Interrupt Shared
CAN-1 Interrupt Not Shared
4
CAN-0 Interrupt Shared
CAN-0 Interrupt Not Shared
5
Shared Interrupt(s) Pull-Down enabled
Shared Interrupt(s) Pull-Down disabled
6
Shorten Memory and I/O Bus Cycles
Normal Memory and I/O Bus Cycles
Table 22
J4 and J5
Position
Function
Jumper Installed
Jumper Removed
T
CAN Bus Termination Resistor enabled
CAN Bus Termination Resistor disabled
G
9D Connector Shell Grounded [Note 1]
9D Connector Shell NOT Grounded
Table 23
The 9D Shell is Grounded to the Isolated Ground for the respective CAN Port.
The 9D Shell is Grounded to the Isolated Ground for the respective CAN Port.