Gigabyte GA-7VA1004 Manual Do Utilizador
- 18 -
GA-7VA Motherboard
English
5)IDE1/ IDE2 (IDE1/IDE2 Connector)
Ø Important Notice:
Please connect first harddisk to IDE1 and
connect CDROM to IDE2.
The red stripe of the ribbon cable must be the
same side with the Pin1.
connect CDROM to IDE2.
The red stripe of the ribbon cable must be the
same side with the Pin1.
IDE2
IDE1
1
1
7)RAM_LED
Ø Do not remove memory modules while
DIMM LED is on. It might cause short or
other unexpected damages due to the
2.5V stand by voltage. Remove memory
modules only when AC Power cord is
disconnected.
other unexpected damages due to the
2.5V stand by voltage. Remove memory
modules only when AC Power cord is
disconnected.
8)PWR_LED
Ø PWR_LED is connect with the system power
indicator to indicate whether the system is
on/off. It will blink when the system enters
suspend mode.
If you use dual color LED, power LED will turn
to another color.
on/off. It will blink when the system enters
suspend mode.
If you use dual color LED, power LED will turn
to another color.
MPD+
MPD-
MPD-
1
+
-
6)FDD (Floppy Connector)
1
Ø Please connect the floppy drive ribbon cables
to FDD. It supports 360K,720K,1.2M,1.44M
and 2.88Mbytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.
and 2.88Mbytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.