Fujitsu B23Q8YA-G-02-F Manual Do Utilizador

 

 

 

   

23 

ok cd /pci@83,2000/FJSV,pwga@1 <Return> 
ok .prp <Return> 

     role                   slave       

*1 

     duplex                 half        

*2 

     transfer-speed       0000000a   

*3 

     cabinet-name          Cabinet#0 
     board-name            Motherboard#1 
     assigned-addresses  83002810  00000000  00100000  00000000  00010000 
                             82002830  00000000  00110000  00000000  00010000 
 

*1: Appears only when slave-mode is set. 

*2: Appears only when half-duplex is set. 

*3: Appears only when transfer-speed is set. [10Mbps:0xa, 100Mbps:0x64] 

In the default, those *1,*2 and *3 are not appeared. 

 

To return to the default setting after setting Fcode Force mode, do as follows: 

On ok prompt screen, implement below command or power-off the system and power-on again. (Implement 

only reset command cannot back to default setting.) 

ok reset-all <Return> 

The procedure which uses fjgi interface to install the Solaris OS via a network from an installation server is 

explained below. 

 

1. 

Setup the install server and the clients to install the Solaris OS. 

About setup of install server and clients, refer to "Solaris 10 Installation Guide." 

2. 

In an installation server, execute the command shown below and check the root directory of a client 

system. The root directory of a client system is described by the /etc/bootparams file of an 

installation server. 

 

# grep CLIENT_NAME /etc/bootparams <Return> 

# grep  CLIENT_NAME /etc/bootparams 
CLIENT_NAME  root=SERVER_NAME:/netinstall/Solaris_10/Tools/Boot 
install= 

In the example, the root directory of this client is set to /netinstall.   

CLIENT_NAME is the name of client system. 

SERVER_NAME is the name of install server.   

When the root directory name is not described by the /etc/bootparams file, please refer to "Solaris 10 

Installation Guide." 

 

3. 

Check the ok prompt of OpenBootPROM is displayed on the client system. 

If OS is booted, please stop a system by the shutdown(1M) command as follows. 

# /usr/sbin/shutdown -i0 -g0 -y <Return> 

# /usr/sbin/shutdown -i0 -g0 –y 
    ....... 

(

shutdown messages are displayed) 

    .......