APC ACRC103 Manual Do Utilizador
15
InRow RC Installation
Stabilizing the Equipment
Floor brackets
To prevent the equipment from moving from its final location (if it is not joined with an enclosure), use
the included bolt-down kit (AR7701). Follow the installation instructions included with the kit.
the included bolt-down kit (AR7701). Follow the installation instructions included with the kit.
Joining to enclosures
NetShelter
™
SX enclosure.
Two
joining brackets are installed on the front
and rear of the equipment. Depending on
how the holes on the joining brackets are
used, you have the option of either 24-in
or 600-mm spacing.
and rear of the equipment. Depending on
how the holes on the joining brackets are
used, you have the option of either 24-in
or 600-mm spacing.
1. Remove the front and two rear
doors from the equipment. See
“Door removal” on page 13.
“Door removal” on page 13.
2. Locate the four joining brackets
on the equipment. Rotate each
bracket 90° toward the adjoining
enclosure so that the bracket is
parallel to the floor.
bracket 90° toward the adjoining
enclosure so that the bracket is
parallel to the floor.
3. Install the brackets using the
Phillips screws provided with the
equipment.
equipment.
NetShelter VX enclosure.
The equipment may be joined to a NetShelter VX enclosure (24-in spacing
only) by using an accessory kit (AR7602), sold separately.
na
15
7
3a