APC 3-16kVA Folheto

 

 

3-16kVA Service Bypass Panels 

©2009 APC by Schneider Electric, APC, the APC logo, and Smart-UPS are             

owned by Schneider Electric industries S.A.S American Power Conversion  

Corporation, or their affiliated companies. All other trademarks are property 

of their respective owners. 

990-1530B

 

 

Note: Read the safety information sheet before installation.  

Illustrations in this document may differ slightly from the actual hardware. 

n 

 

o

 

Set SBP in the rack. If hardwiring is required, see Connecting Power 

section before screwing into the rack. 

 

 

  

n

 

 

o

 

Whenever possible, attach one top screw and one bottom screw into a wall stud. If stud 

mounting is not possible, use an expandable wall anchor. Screws are not included; .25” x 
2” lag bolts are recommended. 

 T

n

  

Remove screw from the top and bottom rear of both the UPS and SBP. Install tie 

brackets and reattach screws.

 

 

 

o

 

Unscrew and remove top cover of the 

UPS.

 

p

 

Attach bracket to top of UPS and SBP.

 

 

 

q

 

Reattach top cover of the UPS.

 

 

 

 

 

 
Note: The SBP5000RMI2U, when used in conjunction with an SURT3000XLI or SURT5000XLI UPS in a 
tower configuration without an external battery pack (SURT192XLBP), is suitable for mounting on 
concrete or other non-combustible smooth surfaces only.

 

 

 

1. Normal: Power is directed from the utility outlet, through the Bypass Panel and UPS, 
and to connected equipment. For use during normal UPS operation. 

2. Test: Power supplied to the UPS is not output. Use when tests are being conducted on 
the UPS, and connected equipment is not yet desired. 
 
3. Bypass: Power from the utility outlet is filtered through the Bypass Panel, and to the 
connected equipment. Use to bypass the UPS, when functioning improperly. 

Note: While operating in ‘Test’ or ‘Bypass’ mode, power to the connected equipment is 
not conditioned by the UPS.  At this time, the “Equipment Protection Policy” is not valid. 

 

Service Bypass Panels will differ. Refer to chart for unit specifications.   

For loads exceeding 3kVA, hardwiring is necessary.

For loads exceeding 5kVA, hardwiring is necessary.