APC AP7900 Manual Do Utilizador
®
USER’S GUIDE
Switched Rack PDU
151
Run the Wizard to perform the configuration.
To discover and
configure, over the network, installed or embedded Network Management
Cards that are not configured:
Cards that are not configured:
1. From the
Start
menu, launch the Wizard. The Wizard automatically
detects the first Network Management Card that is not configured.
2. Select
Remotely (over the network)
, and click
Next >
.
3. Enter the TCP/IP settings (
System IP
,
Subnet Mask
, and
Default
Gateway
) for the unconfigured Network Management Card identified
by the MAC address at the top of the screen. Then click
Next >
.
4. On the
Transmit Current Settings Remotely
screen, if you check-
mark
Start a Web browser when finished
, the default Web browser
connects to the device that contains the Network Management Card
after you transmit the card’s settings.
after you transmit the card’s settings.
5. Click
Finish
to transmit the TCP/IP settings. If the IP address you
entered is in use on the network, the Wizard prompts you to enter an IP
address that is not in use. Enter a correct IP address, and click
address that is not in use. Enter a correct IP address, and click
Finish
.
6. The Wizard searches for another installed or embedded but
unconfigured Network Management Card. If it finds one, it displays the
screen with data entry boxes for the TCP/IP settings of that card.
screen with data entry boxes for the TCP/IP settings of that card.
– To skip configuring the card whose MAC address is currently
displayed, click
Cancel
.
– To configure the TCP/IP settings of the next card, repeat this
procedure beginning at step 4.