Event electronic PS8 Manual Do Utilizador

This jack accepts a ¼” TRS connector, wired either

balanced or unbalanced.

For balanced wiring, a 3-conductor ¼" TRS plug is necessary. See
the INPUT CONNECTIONS wiring chart below or on the amplifier
panel.

Unbalanced wiring works with either a 2 or 3-conductor ¼” TRS
connector.  A 2-conductor ¼" TS plug automatically grounds the
minus signal input, whereas a 3-conductor TRS plug wired
unbalanced provides the option of leaving the minus input open or
grounded.  We recommend that you ground the unused input.

The L

 

connector is hardwired in parallel with the L

 connector, so either may be used as an input or a pass-through

connection.  Input specifications apply to both inputs.

   

This control has a 20dB range and  compensates for

different input signal levels. If too much input signal is present, the amplifiers
may overload, in which case the green LED at the front of the monitor will
flash.  With the

 

control at maximum, 0.9V RMS input

will produce full amplifier output.

The PS5 monitor has an additional front panel 

 (not shown)

that effectively works in series with the rear panel  I

control. The 

 is useful for quick, uncalibrated adjustments

from the front.  With a full input signal applied, turn the front panel 

 to maximum. Starting from minimum, increase the I

to your maximum achievable output level preference.  The front

panel volume control will then attenuate from that operating point.

   

This jack accepts XLR input connections, wired either

balanced or unbalanced.  The  L

 

connector is hardwired in

parallel with the L

 connector, so either may be used as an input

or a pass-through connection.  Input specifications apply to both inputs.

3

     

1 = ON    0 = OFF

When amplifier power is on, the green LED at the front of the monitor will
illuminate.

 This connector accepts the detachable linecord.  Use

the linecord supplied with your monitors and make sure it is fully seated into
the Power Inlet connector.  For safety reasons, do not attempt to defeat the
linecord’s ground connection.  The AC mains fuse is internal.