GE LTC-MAP 2130 Manual Do Utilizador
1-4
Section 1: Introduction
February 3, 2000
70055MP Revision D
General
Relay Outputs Two dry-contact relay outputs for alarm indication.
Front Panel
Indicators
Three LEDs:
POWER: When lit, indicates that the monitor is receiving
power.
ALARM1: When lit, indicates that a software
ALARM1: When lit, indicates that a software
configurable alarm has been activated; contact relay
driven.
ALARM2: When lit, indicates that a software
ALARM2: When lit, indicates that a software
configurable alarm has been activated; contact relay
driven.
Display Front panel four line liquid crystal (LCD).
Resolution: 1 V, 1 A, 1 °C.
Communications Standard: RS-232-C serial port; DB-9 connector.
Optional: 14.4k bps modem, installed on the back left side of
the monitor base.
Data Storage Type: Non-volatile, solid state RAM.
Capacity: Up to 128 K, based on configuration.
Mode: Revolving loop.
Averaging Interval: Configurable from 1 to 60 minutes.
Mode: Revolving loop.
Averaging Interval: Configurable from 1 to 60 minutes.
Controls Three front panel push buttons:
Operating Conditions: Used to display present operating
conditions.
Alarm Status & Settings:
Alarm Status & Settings:
Used to display present alarm status.
Acknowledge Alarm:
Acknowledge Alarm:
Used to deactivate alarm relays.
One CPU Board mounted push button:
SETUP: Used to initiate setup procedure for tap position
calibrations.
Installation Category III.
Maintenance No regular maintenance is required.
Cleaning No regular cleaning is required.
Intermittent
Operation
No specific limit; however, intermittent operation is
undesirable and should be corrected as soon as
possible.