Motorola MVME956UM2 Manual Do Utilizador

Disk and Tape Drive

http://www.mcg.mot.com/literature

5-7

1. Follow the replacement procedure in the installation instructions 

that came with your drive.

Note: Use the short (1/4 inch long) screws to attach the brackets to 
the drive. The longer screws may damage the drives. Ensure that all 
drives are properly identified and that the terminating resistor is 
installed or removed as applicable. 

2. Reconnect the power and data cables.

3. Position the side access cover on the screws to engage the keyhole 

slots properly. The washers must be on the outside of the cover. 

4. When the screws have properly engaged the keyhole slots, slide the 

cover down and tighten the screws. 

11823.00 9708