Atmel AT91CAP7A-STK Folheto
The CAP™ Starter Kit is the ideal vehicle for low-cost, no-risk evaluation of the customization capabilities
of Atmel’s CAP microcontroller. It is intended to familiarize the user with the CAP concept and architecture,
and is an ideal vehicle for students of electronic engineering to consolidate their knowledge of system-
on-chip design, both hardware and software.
of Atmel’s CAP microcontroller. It is intended to familiarize the user with the CAP concept and architecture,
and is an ideal vehicle for students of electronic engineering to consolidate their knowledge of system-
on-chip design, both hardware and software.
CAP comprises a microcontroller-based system-on-chip with ARM
®
processor, memories, peripherals and
standard interfaces, together with a Metal Programmable (MP) Block for application-specific functions.
The CAP Starter Kit facilitates the mapping of application-specific IP blocks into its FPGA that
emulates the functionality of the CAP MP Block, while at the same time providing
a development platform for software for the ARM processor. This enables the
hardware and software of simple applications, or modules of more complex
applications, to be tested at close to operational speed.
The CAP Starter Kit facilitates the mapping of application-specific IP blocks into its FPGA that
emulates the functionality of the CAP MP Block, while at the same time providing
a development platform for software for the ARM processor. This enables the
hardware and software of simple applications, or modules of more complex
applications, to be tested at close to operational speed.
CAP Starter Kit Board
The AT91CAP7A-STK Starter Kit is built on a single PCB, including:
AT91CAP7A-STK
®
Starter Kit
for CAP Customizable Microcontroller
CAP
TM
CUSTOMIZABLE MICROCONTROLLERS
n
AT91CAP7E ARM7TDMI
®
-Based
Microcontroller System-On-Chip
n
64M Bytes SDRAM Memory, 3.3V
n
256M Bytes NAND Flash, 3.3V
n
Altera
®
Cyclone
®
II EP2C8F256C7N (256BGA)
n
Altera Configuration PROM -EPCS4SI8N
n
40-Lead Extension Connector (x3) for I/O
Access
n
2.8 inch TFT Color LCD
n
Two Serial Ports (One Connected to the CAP7
Debug Unit)
n
One USB 2.0 Full Speed Device Port
n
Mini Joy Stick
n
Four Analog Inputs
n
Light Sensor
n
Temperature Sensor
n
Voltage Potentiometer
n
Voltage Regulators (1.2V, 2.5V and 3.3V)
n
Access Points for CAP7 Power Measurements
n
Eight LED’s Four Push Buttons
n
JTAG ICE Connector (CAP7)
n
JTAG ISP Connector (FPGA)
n
POR Circuit for FPGA
n
POR Circuit for CAP7
n
50 MHz OSC