IBM 8310 Manual Do Utilizador
3.
Remove
the
metal
shield
from
the
drive
bay
by
inserting
a
flat-blade
screwdriver
into
one
of
the
slots
and
gently
prying
it
loose.
4.
Make
sure
the
drive
is
set
correctly
as
the
master
device.
Refer
to
the
documentation
that
comes
with
your
CD-ROM
drive
or
DVD-ROM
drive
for
master/slave
jumper
information.
5.
Pivot
the
drive
bay
latch
handle
toward
the
front
of
the
computer
and
then
pivot
the
drive
bay
cage
upward,
as
shown,
until
it
is
latched
in
the
up
position.
6.
Install
the
drive
into
the
bay.
Align
the
screw
holes
and
insert
the
two
screws.
7.
Each
integrated
drive
electronics
(IDE)
drive
requires
two
cables;
a
four-wire
power
cable
that
connects
to
the
power
supply,
and
a
signal
cable
that
connects
to
the
system
board.
To
connect
a
CD-ROM
drive
or
DVD-ROM
drive
to
your
computer,
follow
these
steps:
a.
Locate
the
signal
cable
that
comes
with
your
computer
or
with
the
new
drive.
b.
Locate
the
secondary
IDE
connector
on
the
system
board.
See
c.
Connect
one
end
of
the
signal
cable
to
the
secondary
IDE
connector
on
the
system
board
and
the
other
to
the
CD-ROM
drive
or
DVD-ROM
drive.
54
Hardware
Maintenance
Manual