Intel PX875P Manual Do Utilizador
PX875P PRO/ PX875P
58
Appendix III: Installing a Windows
®
OS
to the SATA HDD
Please refer to the steps below to install a windo
®
ws OS to the SATA HDD
A Port1 Mode” option is
ou need to set either Port0 or
ce has been
®
OS.
1.
Make sure that the “On-Chip Serial ATA” option is set to “ Combined Mode ” in the BIOS
Setup Utility.
BIOS Setup Utility -> Integrated
Peripherals Æ OnChip IDE Device Æ On-Chip Serial
ATA Æ “Combined Mode”
2.
Make sure that either the “Serial ATA Port0 Mode” or “Serial AT
set to “Primary Master” in the BIOS Setup Utility. Note that y
Port1 depending on which SATA drive you are installing the OS to.
set to “Primary Master” in the BIOS Setup Utility. Note that y
Port1 depending on which SATA drive you are installing the OS to.
BIOS Setup Utility -> Integrated
Peripherals Æ OnChip IDE Device Æ Serial ATA
Port0/1 Mode Æ “Primary Master”
3.
Save all BIOS configurations and exit the BIOS setup utility.
4.
Place the Windows
®
98/Me/2000/XP CD into the CD-ROM drive to begin the OS
installation process. During the installation you will see that the SATA devi
assigned to the C: drive. Continue and complete the installation of the Windows
assigned to the C: drive. Continue and complete the installation of the Windows
5.
If you are installing Windows
®
XP, you must now set the“On-Chip Serial ATA"option to
“Auto"or“Enhanced Mode"in the BIOS Setup Utility in order for all of the SATA and
IDE devices to be visible.
IDE devices to be visible.
BIOS Setup Utility -> Integrated
Peripherals Æ OnChip IDE Device Æ On-Chip Serial
ATA Æ “Enhanced Mode” or “Auto”